Assembly is EASY, anyone can do it. All you need is a Phillips head screwdriver. All hardware is included with the horns along with these instructions. Before you begin retrieve all of the items from the box and unwrap them. You should have a loose horn, a horn that is on the mount, the wooden mounting plaque, a leather piece and a bag that contained these instructions and screws. Because of the shape of the horn I have found that the easiest place to assemble them is on your lap. 

 

 

Picture 1

 

First put the loose horn over the wooden end of the mount. Align the arrows on the front and back of the horn with the arrows on the wooden part of the mount.
See picture 1.

 

Next, start all of the other silver screws into the black marked holes on the horn. Once all the screws are started and horn is in place tighten until all screws until they are snug.
See picture 2.

Picture 2

Picture 3

Next take the leather piece and align the end marked BOTTOM, with the bottom holes marked in red on the horn and mount and tighten screws down. Next, wrap the leather piece around the horn and line up the screws with the top holes, marked in red, and tighten.
See picture 3

 

Next insert the long screws into the two top holes of the mounting plaque until about a half inch of the screw shows
See picture 4.

Picture 4

Picture 5

Pick the horns back up and set the screws into the top holes on the mount that are marked in black, on the back of the mount (holes will be marked in silver on horns with black leather centers.) Tighten the screws down until they are snug. 
Screw the remaining two screws into the oak board and tighten down(some horns will only have two long screws.) Once all screws are in place make sure all screws are tight and your horns are ready to be hung.  See picture 5

If you have any problems or questions please call 877-871-5283, or email sales@droverhouse.com and we will be happy to help.